CHAPTER 10 PAPER DECK
8) Remove the five screws [10], and detach
the lifter motor unit [11].
[10]
[10]
[11]
Figure 10-335
6. Routing the Lifter Cable
1) Check to make sure that the lifter drive
shaft and the lifter are held in position[4]
with a hex wrench [1] and long
screwdrivers [2] as shown.
[3]
2) Secure the cable fixing plate [3] to the
lifter with two screws.
[4](front)
3) Hook the lifter cable on the upper pulley
[4].
4) Hook the ball of the lifter cable on the
pulley [5] of the lifter drive shaft, and
wind the cable along the groove about 1.5
[5]
times by hand. At this time, be sure to
keep the lifter cable taut until the long
[6]
screwdrivers used to hold the lifter in
place are lifted as far up as they move.[3]
5) Secure the pulley to the lifter drive shaft
with two set screws [6].
6) Secure all pulleys that have been removed
to the lifter drive shaft, and measure the
distance from the base plate of the[3]
compartment to the top face of the lifter to[6]
make sure that the lifter is level.[5][2]
[1]
[3]
Figure 10-336
COPYRIGHT ? 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)10-33 |
ACEC
